Albrecht Tec talk smart Manuel d'utilisateur

Tectalk Smart + Series User Manual

10• Press the PTT button momentarily to confirm selection. Call Ringer The transceiver provides a transmit call ring melody to alert other users of

11a signal is received, the scan is interrupted and will return to scan mode approximately 5 seconds after the interruption. To enable the channel s

122. The radio has been designed to maximize performance and improve transmission range in the field. To avoid interference, it is recommended that

13Troubleshooting If you have problems with your Tectalk Smart +, reset your unit by turning it off and removing the batteries. And re-insert the bat

14CTCSS Tone Subcode Table No. Freq. NoFreq. No. Freq. No. Freq. 1 67.0 11 97.4 21 136.5 31 192.8 2

15Disposal of defective electronic items The European WEEE Directive does not any more allow to dispose any used electronic items via household trash

16 CE Declaration of Conformity PMR 446 Two-Way-Radio Albrecht Tectalk Smart + This radio complies to all relevant European Standards and Regulati

2 Contents Safety Warning... 3 Equipment and Accessories Supplied ... 3 Powering the Transceiver...

3Thank you for purchasing this Albrecht radio. All our products are built to offer excellent value for money by combining advanced features, great de

4Alkaline Batteries shall not be used, because Alkaline batteries do not meet the requirements for keeping the maximum output power more stable for t

5 Charge Information For charging of rechargeable batteries, only the supplied CE-approved AC adaptor shall be used in compliance with the followin

6Control Buttons (1) Power on-off Button Press and hold the POWER on/off button for at least 2 seconds. You will hear a confirming melody to in

7release the PTT Button to allow reception of incoming signals. Whenever the button is pressed, the transmit icon () will appear. When receiving an i

8• The CTCSS subcode (01-38) will be displayed on the LCD panel if the CTCSS tone frequency function is enabled (not oF). Channel Selection • From s

9 To enable the VOX operation: • From standby mode, press the MODE button 3 times unitil the VOX icon (vox) appears with on or oF. • Press the Up or