Albrecht PMR 446 Manuel d'utilisateur télécharger pdf

Programming Set

for PMR 446 Radio

ALBRECHT Tectalk CONTACT 2

With this programming tool you can configure many settings of the Tectalk CONTACT 2 radio to your

special customer’s wishes. The software is able to read/write data to/from the radio. By the reading

feature it is very easy to clone radios for the same settings.

Please follow the national and European rules and regulations when configuring the radio. Even as

distributor or service partner you may be regarded as responsible for any action which can lead to an

unintended use of this radio, especially if you program frequencies or any setting, which is not covered

by the European PMR 446 regulations, and for which the user may not have any license.

1. Installation

The programmer software is only available for WindowsXP®! Put the CD in your disk drive and

start the installation by a double click on the

EXE

-file. Follow the instructions of the installation

wizard.

After the installation was successful, click on the finish button.

2. Configuration

Connect the Programmer cable to your computer. Wait a moment that the cable is automatically

installed by your PC and open Start Æ SettingsÆ My computer Æ System the Device

manager.

Here is shown, which COM port is used

(automatically) by your PC for this USB-

adapter.

If your PC should need a special driver for

the USB-adapter, you will find some on the

installation-CD.

1 2 3 4

Programming Set for PMR 446 Radio ALBRECHT Tectalk CONTACT 2 With this programming tool you can configure many settings of the Tectalk CONTACT 2 radi

Page 2

Start the programmer tool by Start Æ Program and control the selected COM port. If it is different of the shown one in the device manager, you will h

Page 3

5. Programming the CONTACT 2 Attention! If the customer wishes that default settings should remain in the radio under CH locations 1 to 8, you wi

Page 4

In the step FIX you can fix CTCSS/DCS settings by “Y” (yes), so that is not possible by the user to change it. If you choose „None“ in step CT

Pas de commentaire

Albrecht PMR 446 Manuel d'utilisateur